7 Series E32 735i (M30) SAL
Lift shaft seals out of both bearing caps.
Installation:
Dip new shaft seal in final drive oil.
Drive shaft seals firmly home with special tools 33 1 200
and 00 5 500.
Press out outer bearing race with special tool 33 1 350 / 351.
Caution!
Special tool must engage in the bearing outer race.
Installation:
Press in new outer bearing races with special tool 33 1 365
or 33 1 368 (pressure plate).
The following operations for determining friction torque of the final
drive housing bearing are only required if the bearing IS BEING
REPLACED.
RA Replacing drive pinion with crown wheel (Type G) - final drive removed -
BMW AG - TIS
03.02.2013 22:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -