bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

16 SI Testing Procedure For Emissions Test (AU) On Diesel Vehicles With OBD BMW And MI|Page 30 > < 15 SI Nominal Values Supplement For Emissions Test On New BMW, MINI And Rolls-Royce Mo|Page 28
Page 1
background image

VS-5/Kuss

Baugruppe/Group: 00

00 06 05 (203)

weltweit ausser
USA und
Kanada

Datum/Date:
09/2005

Testing procedure for emissions test (AU) on diesel vehicles with OBD

BMW and MINI

Situation:

In Germany from 1 October 2005, the emissions test (AU) for diesel vehicles with OBD
must be carried out in a new test category 
"Diesel with OBD".

In addition to the current opacity measurement, the following OBD data will be read out
from the engine control unit and evaluated by the Generic ScanTool integrated in the
emissions tester:

Exhaust gas indicator lamp status

Test readiness indicator

Fault codes

The engine data needed for the measurements, for example engine temperature and
engine speed, no longer need to be recorded by separate sensors, such as the oil
temperature probe or engine speed signal (TD) or battery voltage harmonic wave, but
rather are read into the test program from the OBD data.

Affected vehicles:

E87 / 1-Series

E65 / 7-Series

E46 / 3-Series

E83 / X3

E90 / 3-Series

E53 / X5

E60 / 5-Series

MINI D

E61 / 5-Series

Procedure:

1. Diesel vehicles with On-Board Diagnosis (OBD)

All BMW and MINI diesel vehicles produced for the European market from 1 September
2003
 equipped with OBD as prescribed in the EU must be tested in the new test category
"Diesel with OBD"
.

Note:

The diesel model X5 3.0d in the E53, only with automatic transmission and
option 200 "Diesel particulate filter",
 will also be produced from 1 October
2005 with EURO 4 technology.
In this version, an OBD is integrated in the DDE control unit. As a result, these
vehicles models also have to be tested in the new test category "Diesel with
OBD"
.

The new BMW 8-cylinder diesel models BMW 745d launched in 04/2005 as
the E65 / MÜ, BMW code HM 61 and HM 62 as equipped with OBD as part of
the EURO 4 technology and therefore have to be tested in the new test
category "Diesel with OBD".

SI  Testing procedure for emissions test (AU) on diesel vehicles with OBD BMW and MI

BMW AG - TIS

04.02.2013  17:40

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

16 SI Testing Procedure For Emissions Test (AU) On Diesel Vehicles With OBD BMW And MI|Page 30 > < 15 SI Nominal Values Supplement For Emissions Test On New BMW, MINI And Rolls-Royce Mo|Page 28