7 Series E32 740i (M60-2) SAL
Remove plastic thread.
Fit main bearing cover on engine block and tighten down,
refer to 11 21 531
Checking axial clearance:
If necessary, check guide bearing shells, crankshaft and engine
block.
End float,
refer to Technical Data
Check connecting-rod bearing clearance:
On each conrod, install one red and one blue conrod bearing
shell. (Irrespective of color code on conrod shaft.)
Caution!
Note grinding stages on crankshaft.
Grind stages,
refer to Technical Data
Install piston,
refer to 11 25 530
RA Replacing crankshaft (M60)
BMW AG - TIS
05.02.2013 15:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
