7 Series E32 740i (M60-2) SAL
Tightening specifications for main bearing:
1.
Tighten all screws on main bearing cover with jointing torque.
2.
Unfasten screws on main bearing cover 5
3.
Strike back and front of crankshaft with plastic hammer to
center thrust bearing (do not damage crankshaft).
4.
Tighten screws of main bearing cover 5 with jointing torque.
5.
Tighten all screws of main bearing cover with special
tool 11 2 110 or special tool 00 9 120 with torsion
angle.
Tightening torque,
refer to Technical Data 11 11 2AZ
Check axial play.
End float,
refer to Technical Data
Check guide bearing shell, crankshaft and crankcase if necessary.
Tighten threaded protective bushes.
Tightening torque,
refer to Technical Data 11 11 3AZ
Tighten taper screw mount on main bearing (collar screws and
spacer pins).
Note:
Replace collar screws.
Tightening torque,
refer to Technical Data 11 11 3AZ
RA Replacing main crankshaft bearing shell (M60)
BMW AG - TIS
05.02.2013 15:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
