7 Series E32 740i (M60-2) SAL
Insert special tool 11 2 470 in conrod.
Remove conrod with piston from cylinder-head side.
Lift out retaining ring and press out piston pin.
Caution!
Piston and piston bolts are paired and must not be fitted
individually.
Installation
Installation of pistons is described separately from removal.
Assembly sequence for removal and installation is different.
If necessary, replace conrods.
Note:
The conrods can also be replaced individually.
It should be possible to press piston pin into bush by hand using
only slight pressure. Clearance should then be minimal.
RA Removing and installing / replacing all pistons (M60)
BMW AG - TIS
05.02.2013 15:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
