Removing and Installing Oil Pressure Switch for BMW 7 Series E32 740i
12 61 280
Removing and installing/replacing oil
pressure switch (M60, M62)
Switch off ignition.
Unfasten oil filter cover to enable engine oil in filter to flow
back into the oil pan.
M60:
Disconnect connector.
M62:
Unfasten plug connection (1). (Shown here with oil filter
disconnected)
Unscrew and remove switch.
Tightening torque,
refer to Technical Data 12 61 1AZ
Installation:
Screw on oil-filter cover tightly.
Check engine oil level and top up with engine oil if necessary.
RA Removing and installing/replacing oil pressure switch (M60, M62)
BMW AG - TIS
05.02.2013 15:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
