7 Series E32 740i (M60-2) SAL
Lift out snap ring (1).
Remove planet spider I (2) from ring gear II (3).
Installation:
Replace O-ring.
Note installation position of snap ring ends.
Arrange transmission horizontally.
Unscrew bolts.
Note:
If necessary, strike screws when unfastening.
Installation:
Tightening torque,
refer to Technical Data 24 23 1AZ.
Arrange transmission vertically with output end facing downwards.
Secure special tool 24 1 280 to cylinder F (1).
Pull out cylinder F (1).
Installation:
When installing cylinder F, insert guide bolts in two bores
beside bore (B).
Bore (A) in cylinder F and bore (B) in transmission case must
be aligned.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
05.02.2013 16:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 21 -
