7 Series E32 740i (M60-2) SAL
Remove drive pinion and rear bearing outer race.
Press-fit correct thickness of shim (A) and outer bearing race.
Caution!
Do not install the drive pinion at this point, since it is first
necessary to measure and adjust the friction torque of the
new final drive housing bearing.
Press pulse generator wheel (3) off final drive housing.
Caution!
Do not bend the pulse generator wheel.
Installation:
Press on pulse alternator wheel with special tool 33 1 304
(union ring).
RA Replacing drive pinion with crown wheel (Type G) - final drive removed -
BMW AG - TIS
05.02.2013 16:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
