7 Series E32 750iL (M70) SAL
Fit and secure special tool 24 0 011 with dial gauge to the input
shaft.
Fit measuring probe to special tool 24 0 012 with slight preload.
Zeroise measuring scale.
Withdraw input shaft as far as stop and read off measuring value.
Adjust end float to 0.10 . . . 0.30 mm.
If necessary, remove oil supply unit again and install thicker or
thinner shim.
Installation:
Check with special tool 24 3 140 that pump wheel on oil
pump is able to rotate easily.
Unfasten screws (A and B).
Installation:
1. Tighten screws (A) M6x40 crosswise.
2. Tighten screw (B) M5x50.
Tightening torque,
refer to Technical Data 24 31 1AZ.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
07.02.2013 23:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
