7 Series E38 728i (M52) SAL
24 00 585
Dismantling and assembling automatic
transmission (A5S560Z)
(transmission removed)
Secure transmission to assembly frame with special tool
24 0 180.
Drain off transmission oil.
Screw special tool 24 4 000 into torque converter and remove
torque converter.
Installation:
Push the torque converter through the sealing ring until it
reaches the first stop position on the gear shaft.
Manually push and turn the torque converter into the
converter bell housing until the recess of the converter hub
rests in the drive plate of the pump wheel and the torque
converter perceptibly slides in.
The torque converter is correctly installed when the distance
between the surface of the tapped hole at the torque
converter and the contact surface of the converter bell
housing is approx. 29 mm.
Caution!
If the torque converter is incorrectly installed, the drive plate of
the oil pump will be destroyed when the transmission is bolted
to the engine.
RA Dismantling and assembling automatic transmission (A5S560Z)
BMW AG - TIS
26.01.2013 01:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
