7 Series E38 728i (M52TU) SAL
View in direction of travel, left:
Position new gas generator.
Retaining lugs on ITS head airbag gas generator (2) must rest on
edge of bulkhead cross-member (1).
Distance (A) = 21 mm from edge of holder for instrument panel
trim (1) to center of bore hole of retaining lugs on ITS head airbag
gas generator (2).
Mark out position of retaining lugs on ITS head airbag gas
generator on sound insulation (3).
Remove ITS head airbag gas generator.
View in direction of travel, right:
Position new gas generator.
Retaining lugs on ITS head airbag gas generator (2) must rest on
edge of bulkhead cross-member.
Distance (A) = 21 mm from edge of holder for instrument panel
trim (1) to center of bore hole of retaining lugs on ITS head airbag
gas generator (2).
Mark out position of retaining lugs on ITS head airbag gas
generator on sound insulation (3).
Remove ITS head airbag gas generator.
Note:
Following description applies to ITS head airbag gas
generator in direction of travel, left:
For ITS head airbag gas generator in direction of travel, right,
modify the work steps accordingly.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
26.01.2013 21:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -