7 Series E38 728i (M52TU) SAL
Support transmission with a workshop hoist.
Release screws.
Caution!
Do not allow the transmission to hang from the transmission
input shaft during removal and installation as this would
deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Install screws only in conjunction with washers.
Tightening torque, 23 00 1AZ.
Installation:
Pay attention to dowel sleeves.
If necessary, remove dowel sleeves from transmission case and
install in engine block.
Replace damaged dowel sleeves.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disk (with a cloth).
Then use a brush to apply a thin even coating of grease for
lubricating taper splines over the entire area. Also in taper
groove and on guide pin.
RA Removing and installing transmission (S5D 310Z)
BMW AG - TIS
23.02.2013 03:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -