7 Series E38 728i (M52TU) SAL
Press gaiter off constant velocity joint.
Installation:
Inject new grease into constant velocity joint from rubber
gaiter and flange sides.
Grease,
refer to BMW Parts Service.
Insert sealing washer (1) in constant velocity joint.
Detach constant velocity joint with special tool 26 1 070 or
26 1 110 .
Installation:
Drive on constant velocity joint with special tool 23 1 040 or
24 1 040 as far as it will go.
Installation:
Shoulder (1) for sealing washer must point to gaiter.
Toothing must be free from grease.
Thread locking: apply Loctite 648.
Important!
Keep Loctite out of ball paths.
Clean toothing and apply a light coating of oil.
RA Replacing constant-velocity joint for propeller shaft
BMW AG - TIS
23.02.2013 04:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -