7 Series E38 728i (M52TU) SAL
32 41 060
Removing and installing power steering vane
pump (M52TU / M54)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Remove underbody protective plate
•
Slacken drive belt and remove from belt pulley
Disconnect suction and pressure lines from vane pump.
Installation:
Replace sealing ring.
Tightening torque 32 41 3AZ
.
Unfasten screws.
Remove vane pump.
Tightening torque 32 41 1AZ
.
RA Removing and installing power steering vane pump (M52TU / M54)
BMW AG - TIS
23.02.2013 05:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -