7 Series E38 730d (M57) SAL
Route adapter wire set (a) to the electronics box.
Important:
When drilling, make sure there are no cables under the drilling
area.
Mark the drilling point and drill a hole with 9 mm diameter in the
top of the cable duct (1).
Feed adapter wire set (a) with grommet (1) through the hole and
route the wiring harness into the electronics box. Seal the
bushing.
Secure adapter wire set (a) with cable ties at a suitable point.
Open the middle connector X2413, disconnect pins 20, 33 and 35
and tie back.
Connect the wires of adapter wire set (1) to the pins as follows:
BRGN (brown/green) wire to pin 20
BLSW (blue/black) wire to pin 33
WSGE (white/yellow) wire to pin 35
Close the connector.
SI Installation instructions for adapter wire set, E38 M57
BMW AG - TIS
03.02.2013 01:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
