7 Series E38 730d (M57) SAL
32 21 281
Replacing centre tie rod
Caution!
After assembly, measure/adjust front axle alignment.
Unscrew and remove splash guard.
Unfasten nut.
Press tie rod off pitman arm and idler arm with special tool
32 1 190.
Installation:
Replace self-locking nut.
Brace on hexagon socket if necessary.
Tightening Torque,
refer to Technical Data 32 21 3AZ
Loosen left or right clamping screws.
Unscrew and remove tie rod adjusting thread from left or right tie
rod.
Installation:
Coat tie rod adjusting thread with special grease,
refer to BMW Parts Service.
Measure screw-in length of adjusting thread on old tie rod.
Screw in adjusting thread on new tie rod to appropriate depth
in left or right tie rod.
Tightening Torque,
refer to Technical Data 32 21 4AZ.
RA Replacing centre tie rod
BMW AG - TIS
03.02.2013 06:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
