7 Series E38 730d (M57) SAL
37 21 030
Replacing pressure accumulator
After assembly, check oil level,
refer to 32 13 006.
Remove wheel arch trim.
Open pressure relief screw (1) on control valve.
Catch escaping oil.
Disconnect wires.
Unfasten screws (1) and remove pressure accumulator.
Installation:
Tightening torque for the lines,
refer to Technical Data 37 12 1AZ / 2AZ.
Arrangement of bracket:
1.
Tightening torque of screw 9 Nm
2.
Washer
3.
Space bush
4.
Grommet
RA Replacing pressure accumulator
BMW AG - TIS
03.02.2013 07:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
