7 Series E38 730d (M57) SAL
Expose connection point(s) between inner section of wheel arch
and
Side member
Intermediate panel
Trunk cover plate
Wheel housing extension
Expose bracket for rear shelf.
Remove insulating mat from rear shelf and expose connection
points between wheel arch - inner section / rear shelf.
Drill off spot welding.
Take off wheel housing inner section.
Remove scrap metal.
Straighten and grind joint surfaces.
Adapt inside section of wheel arch to fit.
Caution!
First install inside section of wheel arch, then fit straightener
brackets.
Mark out connection points and holes for plug welding.
RA Replacing complete rear left wheel arch
BMW AG - TIS
03.02.2013 08:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
