bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

5 RA Replacing Left Rear Side Panel (partial Replacement)|Page 1882 > < 4 RA Replacing The Rear Left Side Panel|Page 1880
Page 1
background image

41 35 337

Replacing left rear side panel (partial
replacement)

Work instructions,

refer to General Information about body repairs

Remove following parts or loosen them:

Rear bumper

Trunk trim panels

Rear wheel

Luggage compartment lid

Hinge for trunk lid

Battery

Left tail light assembly

Rear wire harness (partially)

Spare wheel

Breather flap

Active carbon filter

Caution!

Seal connections on active carbon filter to ensure that no fuel
vapour can escape!

Remove or cover up other vehicle components in the repair zone
which are at risk from heat, flying sparks and dust.

Define and mark out cutting line down roof gutter.

Dimension (A) = 130 mm from edge of roof gutter to rear window.

Mark dimension (A) over edge of side panel.

Dimension (B) = 50 mm from standard connection point.

Join marked cutting line along roof gutter with end of wheel
housing.

Dimension (A) = 130 mm from edge of roof gutter.

Cut off along cutting lines.

RA  Replacing left rear side panel (partial replacement)

BMW AG - TIS

03.02.2013  08:37

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

5 RA Replacing Left Rear Side Panel (partial Replacement)|Page 1882 > < 4 RA Replacing The Rear Left Side Panel|Page 1880