7 Series E38 730d (M57) SAL
51 12 000
Removing and installing complete rear
bumper
Removing and installing body molding for centre section of
rear bumper,
refer to 51 12 432
Unfasten screw and left/ right expanding screws (1) and lift out
wheel arch finisher (2) to one side.
Unfasten left/ right screw with special tool 51 1 080.
Installation:
For Tightening torque,
refer to Technical Data 51 12 2AZ
Unclip bumper from underside of guide.
Installation:
Insert bumper and ensure it is correctly seated.
RA Removing and installing complete rear bumper
BMW AG - TIS
03.02.2013 08:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
