7 Series E38 730d (M57) SAL
Passenger airbag cover (airbag cover) has been changed.
The retaining strap previously secured to the instrument panel has
been replaced by two retaining straps.
These retaining straps are now secured to a bracket (1).
This bracket (1) is placed on the four retaining screws of the
passenger airbag module and is thus positioned under the
passenger airbag module.
Once the passenger airbag module has been placed on the
retaining screws, the bracket (1) is secured with the retaining
screws to the passenger airbag module.
Note:
Illustration without passenger airbag module.
-
The airbag cover is equipped with a retaining strap, which is
secured to the instrument panel.
Procedure for replacing airbag cover.
When cover is open, cut off retaining strap as near as possible to
instrument panel.
Fit new version of airbag cover, with two retaining straps and
bracket.
Unscrew nuts.
Raise airbag module and move to one side; in doing so, do not
exert any tension on cable.
Twist connector and remove by lifting upwards.
RA Removing and installing or replacing airbag module on passenger side
BMW AG - TIS
03.02.2013 17:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
