7 Series E38 730iL (M60-1) SAL
Tighten tensioning rail by turning the adjusting screw on the
special tool 11 3 390 with special tool 00 9 250 to 1.3 Nm.
Note:
If installation tolerance is unfavorable, attach special
tool 00 9 250 from underside.
Tighten sprocket wheels in following sequence.
The three accessible screws on left exhaust camshaft (5-8), right
exhaust camshaft (1-4), left intake camshaft (5-8), right intake
camshaft (1-4).
Tightening torque,
refer to Technical Data 11 31 3AZ
Remove special tool 11 2 300.
Remove special tools from camshafts.
Turn over engine once.
Tighten down the remaining three screws in exhaust and intake
camshafts in cylinder bank 1-4 firmly.
Tightening torque,
refer to Technical Data 11 31 3AZ
RA Adjusting timing of camshaft(s) (M60)
BMW AG - TIS
05.02.2013 13:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
