7 Series E38 730iL (M60-1) SAL
Punch mark both bearing caps. Unscrew and remove both bearing
caps.
Caution!
Do not mix up bearing caps and spacers.
Secure spacers on bearing cap with a piece of wire, if necessary.
Installation:
Tightening torque,
refer to Technical Data 31 11 2AZ.
Differential housing mounts and torsional face runout are set
using the shims (1).
Check O-ring (2), replace if necessary.
Remove complete differential case.
Caution!
Do not bend the pulse generator wheel.
Remove lockplate.
Unfasten nut (1) and brace with special tool 23 0 020.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
05.02.2013 16:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
