7 Series E38 730iL (M60-1) SAL
Do not apply grease to brake pad backplate.
Check dust sleeve (1) for damage and replace if necessary.
Clean contact face (2) of brake piston and apply a thin coating of
anti-squeak compound.
Anti-squeak compound,
refer to BMW Service Operating Fluids
Important!
Dust sleeve must not come into contact with anti-squeak
compound as this may cause the dust sleeve to swell.
Important!
In E39/Touring models, make sure the insulating ring (1) is
installed on the brake piston.
Clean mounting faces (1) and (2) of brake lining hammer
heads/brake caliper housing and coat with anti-squeak compound.
Anti-squeak compound,
refer to BMW Service Operating Fluids
Clean contact face (3) of brake caliper and apply a thin coating of
anti-squeak compound.
Anti-squeak compound,
refer to BMW Service Operating Fluids
RA Removing and installing or replacing brake linings on both rear disk brakes
BMW AG - TIS
05.02.2013 17:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -