7 Series E38 730iL (M60-1) SAL
34 31 181
Removing and installing/replacing expansion
tank for hydraulic brake actuation
Caution!
Follow general instructions,
refer to 34 00 ...
Suck the brake fluid out of the expansion tank. Use a suction
bottle used exclusively for drawing off brake fluid.
Pull off supply hose (1) of clutch hydraulic system if necessary.
On vehicles with a precharging pump for DSC, the supply hose
must be secured in a vertical position to prevent fluid from
emerging.
Lift out the expansion tank (2) from the master brake cylinder by
tilting it laterally.
Installation:
Check rubber plug in master brake cylinder; no damage may
be present.
Push the expansion tank vertically onto the master brake
cylinder.
RA Removing and installing/replacing expansion tank for hydraulic brake actuation
BMW AG - TIS
05.02.2013 17:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
