7 Series E38 740i (M60-2) SAL
Disconnect Bowden cables for throttle valve actuation.
This operation is described in section on removing and
installing/sealing the throttle body,
refer to 13 54 030
Disconnect plug connection (2) and vacuum hose (3) from tank
vent valve.
Unfasten engine section of wiring harness and placing to one side
with cable ducts,
refer to 12 51 001
Unclip diagnosis connector on spring strut shock absorber and
place to one side.
Unfasten heat baffle plate on left and right sides.
Unfasten drain plug for coolant in left and right engine block.
Drain and dispose of coolant.
Installation:
Replace sealing ring.
Tightening torque,
refer to Technical Data 11 11 5AZ
RA Removing and installing engine (M60)
BMW AG - TIS
11.02.2013 06:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -