7 Series E38 740i (M60-2) SAL
Coat contact surface between engine block and timing case with
Hylomar SQ 32 M (refer to BMW Parts Service).
Check that dowel sleeves are undamaged and correctly located.
Place new cylinder head gasket in position.
Put the cylinder head on.
Do not wash off bolt coating. Install new cylinder head bolts.
Note:
Use special tool 00 9 120 for torsion angle tightening.
Tighten down cylinder head screws in sequence 1 ... 10.
Tightening torque,
refer to Technical Data 11 12 8AZ.
RA Removing and installing right cylinder head (M60)
BMW AG - TIS
11.02.2013 06:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -