7 Series E38 740i (M60-2) SAL
Installation:
Check seal and gasket and replace if necessary.
Note:
To prevent the propagation of vibration, the intake manifold is
separated from the cylinder head by decoupling elements and
gaskets.
(1)
Nut
(2)
Decoupling element
(3)
Intake air manifold
(4)
Seal
Installation:
Fit two decoupling elements on left and right with nuts and do
not tighten (i.e. no preload).
Align intake air manifold.
Fit all other decoupling elements with nuts and tighten
crosswise from inside to outside.
Tightening torque,
refer to Technical Data 11 61 1AZ
Installation:
Check gaskets and replace if necessary.
Caution!
Ensure that gaskets are correctly seated.
RA Removing and installing intake air manifold (M60)
BMW AG - TIS
11.02.2013 06:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -