7 Series E38 740i (M60-2) SAL
13 62 560
Removing and installing/replacing mass air
flow sensor (M60, M62, M73)
Interrogate fault memory of DME control unit.
Switch off ignition.
Disconnect plug connection (1) from air-mass flow sensor.
Release hose clip (2).
Detach intake hose from air-mass flow sensor.
Open clips (1).
Detach air-mass flow sensor from air cleaner upper section.
Installation:
Check seal (1) between air-mass flow sensor and air cleaner
upper section for damage, replace if necessary.
To facilitate assembly, coat seal with acid-free grease.
Read out fault memory of control unit of Digital Motor Electronics
(DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Removing and installing/replacing mass air flow sensor (M60, M62, M73)
BMW AG - TIS
11.02.2013 07:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -