7 Series E38 740i (M60-2) SAL
Installation:
Replace rubber gasket.
Caution!
The "white foam seal" used as protection against dust and dirt
during transport may never be used for installation of the fuel
level sensor. This transport seal is not fuel-resistant and will
result in leakage of the fuel level sensor.
Installation:
Install the sensor in such a way that the arrow "Open" points
to the arrow on the fuel tank.
Turn the sensor to the right until the arrow "Closed" points to the
arrow on the fuel tank.
RA Removing and installing / replacing the sensor for the fuel level gauge (left)
BMW AG - TIS
11.02.2013 07:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -