7 Series E38 740i (M60-2) SAL
Remove transmission extension.
Installation:
Replace O-ring.
Installation:
Install shim.
If new output flange and/or new bearing is installed, adjust end
float,
refer to 24 13 156.
Clamp special tool 24 0 190 in vice.
Fit transmission extension to the special tool.
Knock back cotter pin in grooved nut.
Installation:
Peen grooved nut to secure.
RA Replacing radial seal for output flange (A5S 560Z)
BMW AG - TIS
11.02.2013 08:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -