7 Series E38 740i (M60-2) SAL
26 11 090
Removing and installing or replacing center
mount of propeller shaft
Special tools required:
•
00 5 500
•
11 1 310
•
11 2 030
Necessary preliminary tasks:
•
Remove propeller shaft.
Pack centering bore fully with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centering
bore.
The center mount is forced out by applying pressure to grease fill
(1).
If necessary, top up grease repeatedly.
Note:
To drive out the mount, you can also fill the centering bore
with water instead of grease.
Remove grease/water from mount bore.
Drive in centering (1) with special tools 00 5 500 and 11 2 030
until protrusion (A) is reached.
RA Removing and installing or replacing center mount of propeller shaft
BMW AG - TIS
11.02.2013 09:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -