7 Series E38 740i (M60-2) SAL
32 00 620
Adjusting rear axle
Important!
A nut must be replaced if it has been tightened down and
released more than 10 times.
Note:
A camber change always means a toe change as well. The
camber must therefore be adjusted first.
Adjusting camber:
Unfasten nut.
Check installation position of eccentric screw and eccentric
washer, correct if necessary.
Replace nut and tighten down.
Tightening torque 33 32 22AZ
.
Slacken nut by approx. 0.5 to 1 turn.
Turn eccentric screw to adjust camber to specified value.
RA Adjusting rear axle
BMW AG - TIS
11.02.2013 10:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -