7 Series E38 740i (M60-2) SAL
Press outer bearing race out with special tool 33 1 350 / 351.
Caution!
Special tool must engage in the bearing outer race.
Installation:
Press new outer bearing race in with special tool 33 1 373.
The next 12 operations can only be omitted if the differential
housing bearings are not being replaced:
Install differential housing with new crown wheel and new bearing.
Lubricate bearing thoroughly with approved final drive oil,
refer to BMW Service Operating Fluids,
and allow to drip.
Installation:
Install lateral bearing cover as indicated with the appropriate
shims (1), but without O-ring (2).
Uniformly tighten screws securing the bearing cover opposite of
the crown wheel.
Tightening torque,
refer to Technical Data 33 11 2AZ.
Installation:
Compensating bores (1), which can be identified by the
outside tab (2), always face up in installed position of
transmission.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
11.02.2013 10:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -