7 Series E38 740i (M60-2) SAL
Unlock central connector (1) and pull off.
Unfasten nut (2) and remove ground wire.
Note:
Keep brake fluid out of cable connector.
Unfasten brake lines.
Caution!
Do not mix up brake lines, mark before removing if necessary.
Installation:
Line connections
(F) from THZ circuit F to hydraulic control unit circuit F (front-
axle circuit)
(R) from THZ circuit R to hydraulic control unit circuit R (rear-
axle circuit)
(FR) from hydraulic control unit FR to front right wheel brake
(FL) from hydraulic control unit FL to front left wheel brake
(RA) from hydraulic control unit RA to rear-axle wheel brake
Tightening torque, refer to Technical Data 34 32 1AZ
Unfasten screw and remove hydraulic control unit.
RA Removing and installing / replacing ABS hydraulic control unit
BMW AG - TIS
11.02.2013 11:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -