7 Series E38 740i (M60-2) SAL
41 61 014
Aligning engine hood
Note:
Engine hood was fitted and bolted in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Code on aluminum engine hood:
Clinch points on edge of engine hood.
With aluminium parts, refer to:
41 00 ... Basic comments on handling aluminium components
41 00 ... Notes on repairs on aluminium parts
Adjust detent screws on left and right screw connection (1) to
dimension (A).
A = 16
±
1 mm
Note:
Detent buffer (2) must not be damaged. Replace hinge if
necessary.
Caution!
Bowden cable on both hood locks must be set to zero
backlash.
Entire sleeve on Bowden cable must locate in guide in lock,
otherwise, when release lever is pulled, Bowden cable slips
into guide and it is no longer possible to open locks.
RA Aligning engine hood
BMW AG - TIS
11.02.2013 13:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -