7 Series E38 740i (M60-2) SAL
Adjust cable on adjusting fixture to be without play.
Caution!
Cable must not have tension.
If necessary, adjust actuating stroke of Bowden cable.
Turn back detent buffer without ejector.
Detent buffer with ejector:
Press ejector into detent buffer and, in this position, twist slightly to
left with a Phillips screwdriver.
This locks the ejectors in the detent buffers.
Fitting in engine hood:
Caution!
Do not damage intermediate plate between hinge and hood:
replace if necessary.
Loosen bolts (1 and 2) of left and right hinges.
Note:
If the adjusting range is not sufficient, loosen engine hood
mounting bolts on body and adjust hinge on body.
RA Aligning engine hood
BMW AG - TIS
11.02.2013 13:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -