7 Series E38 740i (M60-2) SAL
Measure and, if necessary, correct distance (A) = engine hood
protrusion beyond the headlight lens.
Dimension (A) = approx. 2 mm
Detent buffer without ejector:
Unscrew detent buffer until hood lid is flush with detent buffer.
Detent buffer with ejector:
Unscrew detent buffer until hood lid is flush with detent buffer and
ejector.
Gently twist ejector in detent buffers to right with Phillips
screwdriver. This unlocks the detent buffers, enabling ejector to
emerge.
To adjust protrusion, loosen nut (1), untighten adjusting nuts (3)
and align headlight to appropriate extent.
Caution!
Do not apply distorting load to headlight: if necessary adjust
lower screws (2).
Check headlight adjustment and adjust if necessary,
refer to 63 10 004
RA Aligning engine hood
BMW AG - TIS
11.02.2013 13:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -