7 Series E38 740i (M60-2) SAL
51 12 000
Removing and installing complete rear
bumper
Removing and installing body molding for centre section of
rear bumper,
refer to 51 12 432
Unfasten screw and left/ right expanding screws (1) and lift out
wheel arch finisher (2) to one side.
Unfasten left/ right screw with special tool 51 1 080.
Installation:
For Tightening torque,
refer to Technical Data 51 12 2AZ
Unclip bumper from underside of guide.
Installation:
Insert bumper and ensure it is correctly seated.
RA Removing and installing complete rear bumper
BMW AG - TIS
11.02.2013 13:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -