7 Series E38 740i (M60-2) SAL
Sealing connections on hydraulic control unit and hose
connections for hydraulic cylinder:
For the hydraulic control unit, use the plugs (1) from the "Hollow
union bolts for hydraulic control unit" set (sourcing reference:
BMW Parts Service) and the old seals.
For the hose connections, use the plugs with cap nuts (2) from the
"Hollow union bolts for hydraulic cylinder" set (sourcing reference:
BMW Parts Service) and the old seals.
Installation:
Always install new hollow union bolts (1) and seals (2 and 4)
(sourcing reference BMW Parts Service).
1
Hollow screw
2
Upper seal (thin)
3
Hose connection
4
Lower seal (thick)
Disconnect plug connection (1) and release nuts (2).
Remove hydraulic control unit (3) and set down on cloth (4).
Installation:
During installation, do not damage PDC control unit.
Disconnect plug connection (1) and withdraw hydraulic control
unit (2).
RA Removing and installing/replacing hydraulic control unit for operating trunk lid
BMW AG - TIS
11.02.2013 13:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -