7 Series E38 740i (M60-2) SAL
Immediately before installing windshield,
remove glue residue in body cutout to approx. 0.5 mm thickness.
To avoid damaging paintwork in body cutout,
carefully remove glue residue with a scalpel.
Caution!
Clean freshly cut residual glue bead with 2-propanol or glass
activator only;
do not, under any circumstances, use Sika bonding agent
205/5.
Installation of spacer buffers:
Two different spacer buffers are fitted. Keep exactly to the
installation position (risk of broken windshield).
1
Square spacer (height stop, wind noises)
2
Semicircular spacer buffer (spacing for adhesive bead)
(A) 3.8 mm
Caution!
Wind noises may result if measurement (A) is not 3.8 mm.
Version with slide/tilt sunroof:
Stick square spacer (1) at distance (A) to center, near water
drainage bore (2), for
slide/tilt sunroof on left/right.
(A) 5 mm
Model without sliding/tilting sunroof:
Attach square spacer (1) to center of cavity (2).
Note:
The water drainage bore is located here in models fitted with
sliding/tilting sunroofs, see one work step previously.
RA Removing and installing front windscreen
BMW AG - TIS
11.02.2013 14:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -