7 Series E38 740i (M60-2) SAL
Open both front doors.
Secure HR foam blocks (2) with plastic adhesive tape (1) (Tesa).
Pretension windshield with plastic adhesive tape (1) (Tesa) until it
is correctly positioned at top (refer to two work steps before).
Note:
Do not stick plastic adhesive tape (1) above A-pillar
finisher (3) or ITS head airbag.
Caution!
Remove contamination caused by residual adhesive
immediately with Sika remover 208 (sourcing reference: BMW
Parts Service).
Do not press out windscreen glass again for this purpose.
Hardened glue can only be removed by machine.
Assemble car.
After the hardening time, remove support and adhesive tape.
Note:
Locate leakage:
(A) by spraying water underneath sealing lips
(B) with an ultrasonic leak detector
(sourcing reference: BMW Parts Service)
If necessary, seal off leakage with corresponding nozzle.
RA Removing and installing front windscreen
BMW AG - TIS
11.02.2013 14:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -