7 Series E38 740i (M60-2) SAL
86 10 ...
Removing trailing arm, removing and
installing or replacing mounting
Replace bearing in trailing arm if there is play in trailing arm.
Note:
Remove brake cable,
refer to 86 10 ... Removing brake shoes.
Remove shock absorber and coil spring,
refer to 86 10 ... Removing and installing coil spring.
Release screws (1) between wheel brake (2) and trailing arm (3)
and remove complete wheel brake (2).
Installation:
Do not reuse screws (1). Use only the socket-head cap
screws intended for this purpose. Stamped arrow on the
reverse side of the brake carrier points in the direction of
travel and stands at the 12 o'clock position.
Tightening Torque,
refer to Technical Data 86 10 24AZ.
The trailing arm folds down once the coil spring on the arm has
been released.
No persons should be located underneath trailing arm. Risk of
injury!
Release screws (1, 2). Use assembly hole (3) to release screw
connection (2).
Press out screws (1, 2) with a mandrel.
Installation:
Use new self-locking nut.
Tightening Torque,
refer to Technical Data 86 10 25AZ.
RA Removing trailing arm, removing and installing or replacing mounting
BMW AG - TIS
11.02.2013 19:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -