7 Series E38 740i (M60-2) SAL
86 21 ...
Attaching/replacing BMW badge
Position of attachment: inside of rear lid
Remove plastic cover (1) from bore holes (2).
Inserting a set of pointed pliers through bore holes (1), detach
retaining washers (2) from pins of BMW badge.
Installation:
Use only new retaining washers.
Caution!
Instruction for removing BMW badge:
Slide a blunt object (e.g. a wooden wedge) under the BMW
badge and carefully lever off the badge.
Position of attachment: outside of rear lid
The BMW badge must be attached at room temperature.
Degrease bonding area with petroleum ether.
Rub down bonding area with a dry cloth.
Peel off protective film on BMW badge (1).
Insert BMW badge (1) with pin (2) into bore hole (3). If bore holes
(3) are considerably larger than pin (2), optically align BMW badge
(1) exactly.
Press down BMW badge (1) firmly.
RA Attaching/replacing BMW badge
BMW AG - TIS
11.02.2013 19:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -