7 Series E38 740i (M62) SAL
Installation:
Clean gasket residue from sealing surface.
Apply thin, uniform bead of Drei Bond 1209 (refer
to BMW Parts Service) to transmission area on half-moon
sections.
Installation:
Check that side of gasket is correctly seated and check back
of cylinder head.
Installation:
Screw two retaining elements to the locating points, without
preload at this stage, and align the cover. Install all other
retaining elements and tighten crosswise from inside to
outside.
RA Removing and installing/sealing both cylinder head covers (M62)
BMW AG - TIS
12.02.2013 14:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
