7 Series E38 740i (M62) SAL
Note:
The continuity test with the multimeter described in the following is
not possible on the M62 B46 because of the different design of
the camshaft adjustment unit.
The remaining procedure is identical.
Connect a commercially available multimeter to a contact pin on
camshaft adjustment unit and to the screw connection on oil line
on cylinder bank 1 to 4.
Set multimeter to acoustic continuity test.
Attach special tool 11 6 440 to camshaft adjustment unit on
cylinder bank 1 to 4 and move at 40 Nm to left-hand stop.
Check left-hand stop of camshaft adjustment unit with acoustic
continuity test on multimeter.
Caution!
Left-hand threads.
Tighten screw connection (2) of inlet camshaft on cylinder
bank 1 to 4 to an initial torque of 15 Nm and then slacken off
again by a 1/4 turn.
RA Adjusting camshaft timing (M62 VANOS from 9/98)
BMW AG - TIS
12.02.2013 14:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -