7 Series E38 740i (M62) SAL
Make sure that contact points on plain compression rings snap
into place.
Align contact points of compression rings upwards.
Make sure that gasket is secured in groove on camshaft bearing
cover.
Apply a light coat of oil to camshaft adjustment unit distributor and
plain compression rings.
Carefully push on camshaft adjustment unit distributor so that it is
straight.
Note:
Only screw (1) with sealing ring.
Replace sealing ring on screw (1).
Install and tighten down screws.
RA Removing and installing/replacing distributor on left camshaft adjustment unit (
BMW AG - TIS
12.02.2013 15:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
