7 Series E38 740i (M62) SAL
12 14 550
Replacing control unit (Digital Motor
Electronics) (M52, M60, M62)
Caution!
Follow instructions for removing and installing electronic
control units,
refer to General Information MG 12.
Switch off ignition.
Unfasten screws.
Tightening torque: 4.4 Nm
Remove cover from control unit box.
Unfasten plug connection (1).
Remove control unit (2).
For subsequent procedure, refer to instructions in DIS tester.
Code control unit,
refer to 12 14 700.
Program control unit,
refer to 12 14 705.
Read out fault memory of control unit of Digital Motor Electronics
(DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Replacing control unit (Digital Motor Electronics) (M52, M60, M62)
BMW AG - TIS
12.02.2013 15:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
