7 Series E38 740i (M62) SAL
Unfasten screws.
Installation:
Replace self-locking nuts.
When tightening the screws, always brace screw and tighten
down nut. This prevents the flexible coupling from being
subjected to torsion stress.
Tightening torque,
refer to Technical Data 26 11 1AZ.
Brace propeller shaft on center mount and loosen nuts.
Installation:
Preload center bearing in direction of travel to dimension (A)
2...4 mm.
Center bearing must be aligned at right angles to propeller
shaft.
Tightening torque,
refer to Technical Data 26 11 6AZ.
Important!
Do not allow propeller shaft to drop into the joints
Joints and rubber sleeve on constant velocity joint can be
damaged.
RA Removing and installing automatic transmission (M62 with A5S 440Z)
BMW AG - TIS
12.02.2013 17:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
