7 Series E38 740i (M62) SAL
Note 3:
Position coil spring between spring holders so that
1. lower spring end (1) lies below spring holder;
2. lower spring end (1) aligns with end (2) of spring holder;
3. 3 coils lie between spring holders.
Warning!
During clamping operation, spring coils in upper and lower
spring holder must locate completely in recess.
Special tool 31 3 341 must not be tensioned or unfastened
with an impact screwdriver.
The coils may not be tensioned on a block.
Check rubber gaiter, auxiliary spring and spring washers and
replace if necessary.
Note assembly sequence, refer to Arrangement for spring strut
shock absorber.
Ends of coil spring must be located in shoulders of spring
retainers.
Replace self-locking nut and tighten with special tool 31 2 210
or with open-end socket tool (width across flats 24) while bracing
with open ring spanner.
Tightening torque 31 31 2AZ
.
RA Replacing front left or right spring strut shock absorber
BMW AG - TIS
12.02.2013 18:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
